ALOY0018K

Complete Lower Control Arm Kit (Lightweight Alloy Adjustable with DuroBall) for the 2013 to 2014 Audi A3 MK3 8VS Saloon / Limousine 1.4 TFSI

SuperPro's lightweight alloy front control arm kits deliver more caster, camber and eliminate unwanted flex.

Exclusive to SuperPro, their alloy arms feature DuroBall rear bushings which are spherical joints embedded in the firm's unique Polyurethane for incredible control without introducing noise, vibration or harshness.

These arms are the best upgrade available. Caster and camber increase gives more steering weight and feel as well as more fun.

ALOY0018K offers a 38% weight saving over the OE arms, increased strength, increased caster, increased camber and much longer service life than the standard factory arms...and they look incredible too!

SuperPro Tip:
Care needs to be taken with aggressively lowered vehicles with non standard tyre and wheel packages to avoid tyre/guard contact.

We also offer standard alignment steel front control arms (TRC1070-MOD) for the same MQB-chassis vehicles which, although they are heavier and don't feature caster increase bushes / anti-lift, they do have upgraded SuperPro bushes so will be a long-lasting simple upgrade.

These arms have inbuilt caster and camber change and are designed to move the lower ball joint forward and out to increase the caster by 1 Degree and induce a negative camber change of up to 0.5 Degrees.

These enhancements are the optimal settings over standard to produce a better handling vehicle.

SuperPro has stringently tested these control arms on the Golf 7 GTi, R and Audi A3 RS3 in both standard configuration and with lowered springs.

The sub frame in these vehicles has no positive location and there is a lot of movement allowable in the bolt holes. Therefore, it is critical that sub frame is not misaligned during re-installation. For this reason and for proper clearance it is critical the sub frame be in the most rearward position when torqued up. These arms have not been tested with any aftermarket engine mount packages that may cause a sub frame misalignment and care must be taken.

The recommended lowered front centre of the wheel is 330mm. See fitting instruction for more